The Ellipse PropertyManager controls the following properties of a sketched Ellipse or Partial Ellipse.
Relations
. Displays relations inferenced
automatically during sketching or created manually with Add Relations. When
you select a relation
in the list, a callout
is highlighted in the graphics area.
Information
. Displays the status
of the selected sketch entity (Fully
Defined, Under Defined,
and so on).
You can add relations to the selected entity. The list includes only relations that are possible for the selected entity.
For construction. Converts the entity to construction geometry.
You can specify any appropriate combination of the following parameters to define the ellipse if the ellipse is not constrained by relations. When you change one or more parameters, the other parameters update automatically. Some parameters are available only for a Partial Ellipse.
|
|
Center X Coordinate |
|
|
Center Y Coordinate |
|
|
Start X Coordinate (Partial Ellipse only) |
|
|
Start Y Coordinate (Partial Ellipse only) |
|
|
End X Coordinate (Partial Ellipse only) |
|
|
End Y Coordinate (Partial Ellipse only) |
|
|
Radius 1 |
|
|
Radius 2 |
|
|
Angle (Partial Ellipse only) |
