Under Variable Radius Parameters, set the radius values for the five vertices as shown in the illustration.
Select V1
in the Attached Radii 
box.
Set Radius
to 1, then press
Enter.
The value 1mm appears for vertex
V1 in Attached
Radii and in the callout in the graphics area.
For each remaining vertex, set the radius to match the corresponding value shown in the illustration.
Select
V2 in Attached
Radii , set Radius
to 1.5, then
press Enter.
Click Set Unassigned to set the remaining radii to 1.5.
Select
V5 in Attached
Radii , change Radius
to 1, then press
Enter.
The values for each of the vertices appear in the list. The fillet previews appear in the graphics area.
Click OK
.
To verify the radius values,
double-click VarFillet1 in the
FeatureManager design tree. The values appear in the graphics area. Click
anywhere in the graphics area to hide the values.
Click Shaded
With Edges 
on the View toolbar.
Save the part.
