Click Hole Wizard
(Features
toolbar).
In the PropertyManager, on the Type tab, under Hole Specification, select:
The following steps give you practice creating Hole Wizard holes. However, because these holes are not part of the model design, you remove them after placement.
Click Hole Wizard
(Features
toolbar).
In the PropertyManager, on the Type tab, under Hole Specification, select:
Countersink
for the hole type.
Ansi Metric in Standard.
Flat Head Screw - ANSI B18.6.7M in Type.
M6 in Size.
Under Options:
Select Head clearance.
Set Head Clearance
to 1.
Select Added C'Bore in Head Clearance Mode to apply additional head clearance as a 1mm counterbore.
Select the Positions tab, then place two holes on the centerline approximately as shown.
