To simulate the Wire Cut Angle Operation you just defined, click on the Simulate button.
The Simulation control panel is displayed.
Click on the Play 
button on
the Simulation control panel to
see the simulation of the wire cut process.
Switch to the SolidVerify simulation by clicking on the SolidVerify simulation page.
Play the simulation.
After
the simulation click on the 
button to undraw the bulk
material removed by wire cutting.
The Show/Hide split solids dialog box is displayed.
Switch between the solids to display the part without the removed material.
Close the Show/Hide split solids dialog box with the Exit button.
Close the simulation with the Exit
button.
Close the Wire Cut Angle Operation dialog box with the Exit button.
You have now finished the lesson.
Congratulations!
