Number of Undo Levels

Sets the number times you can consecutively undo camera/viewpoint moves in a 3D view.

Mouse Mapping

Specifies how the mouse buttons are mapped when the Nav tool (S key) is activated. You can choose the standard XSI mapping or the alternate mapping.

XSI Mouse Mapping:

• Left Mouse Button: Tracking/Pan

• Middle Mouse Button: Zoom/Dolly

• Right Mouse Button: Orbit

• Shift + Left Mouse Button: Constrained Tracking/Pan

• Shift + Middle Mouse Button: Roll

• Shift + Right Mouse Button: Constrained Orbit

• Ctrl + Left Mouse Button: Rect Zoom (drag left to right to zoom in and right to left to zoom out)

• Ctrl + Middle Mouse Button: Rect Zoom Out

Alternate Mouse Mapping:

• Left Mouse Button: Orbit

• Middle Mouse Button: Tracking/Pan

• Right Mouse Button: Zoom/Dolly

• Shift + Left Mouse Button: Constrained Orbit

• Shift + Middle Mouse Button: Constrained Pan

• Shift + Right Mouse Button: Roll

• Ctrl + Left Mouse Button: Rect Zoom (drag left to right to zoom in and right to left to zoom out)

• Ctrl + Middle Mouse Button: Rect Zoom Out

Use Alt Key for View Navigation

When on, you can activate the Nav tool by holding down the Alt key. The tool will obey the mouse mapping specified by the Mouse Mapping setting.

Orbit Around Selected Components

These options control whether the camera orbits selected components or the normal camera interest.

Off: the orbit tool will always orbit around the camera’s point of interest.

On: if you are in object selection mode, the orbit tool orbits the camera around the selected object, rather than the normal camera interest. If you are in component selection mode, using the orbit tool orbits the camera about the selected components.

Components Only: if you are in object selection mode, the orbit tool orbits the camera around the normal camera interest. If you are in component selection mode, using the orbit tool orbits the camera about the selected components.

Orbit Speed

Changes the speed at which the Nav tool’s Orbit function orbits. Increasing the value increases the speed.

Pan Speed

Changes the speed at which the Nav tool’s Pan function pans. Increasing the value increases the speed.

Zoom/Dolly Speed

Changes the speed at which the Nav tool’s Zoom/Dolly function zooms and dollies. Increasing the value increases the speed.

Zoom In/Out

Sets the rate for zooming in units per second higher values cause faster zooming, and vice-versa.

Zoom on Cursor

When activated, zooming in focuses on the mouse pointer position instead of the 3D view’s center.

Look Speed

Controls the speed for “looking” with the mouse, in units per second, while using the Walk or Fly tools. Higher values cause faster movement ad vice-versa.

Forward

Controls the speed for forward and backward motion, in units per second, while using the Walk or Fly tools. Higher values cause faster movement ad vice-versa.

Sideways

Controls the speed for leftward and rightward motion, in units per second, while using the Walk or Fly tools. Higher values cause faster movement ad vice-versa.

Slow Multiplier

The factor by which speed is adjusted for slow movement (Middle Mouse Button) while using the Walk or Fly tools.

Fast Multiplier

The factor by which speed is adjusted for fast movement (Right Mouse Button) while using the Walk or Fly tools.

Speed

Specifies the acceleration factor for the Drive tool.

Turn (deg/sec)

Sets the speed at which the drive tool turns, in degrees per second.

Up/Down (units/sec)

Sets the speed at which the drive tool looks up and down, in units per second.

Show Guide

Displays the overlay guide for the Drive tool.