System Toggles Dialog Box

Valve Stem

When the value is set to ON, the user will be prompted to select the orientation of the stem on every valve placed, or to decide that no stem should be placed for individual valve

When the value is set to OFF, stems will never be placed when the valves are placed.

Spec Check

When this value is set to ON, the user will be prompted to select When you insert affected components, dialog boxes prompt you to select from a variety of spec options associated with that component.

For example, when you insert flanged or welded ball valves, check valves and plug valves, a dialog box prompts you to select a valve type. When you insert screwed/socket weld valves, a dialog box prompts you to select a valve rating.

Branch Check

When the value is set to ON, the branch connection table within the active spec will be checked for each branch component placed, such as a reducing tee or an olet.  If the component selected for the active main and branch size does not match the branch connection table, a warning will be issued.

When the value is set to OFF, the branch connection table will not be checked.

Full Circle for Elbows Up

When the value is set to ON, an elbow placed in the orientation shown below will have the circle placed in the same layer as the component.

When the value is set to OFF, an elbow placed in the orientation shown below will have the circle placed in the DEFPOINTS layer.

Click to apply the changes.

Click to access the Help dialog box.