www.kxcad.net Home > ProCAD Index > ProCAD 2D DESIGNER 2007
If you click Yes under Number Terminals when inserting the terminal block, AutoELECTRIC automatically numbers the terminal.
Use this procedure number an existing non-numbered terminal block.
From the Terminal Blocks tab, select Terminal Block Numbering.
In the drawing, click the first terminal block.
The Terminal Numbering dialog box appears.
In this dialog box, do the following:
|
In this… |
Do this… |
|
Starting Number input box |
Type the number at which you want the terminal numbering to start |
|
Increment input box |
Type the value by which you want the terminal numbering to increase |
|
Prefix input box |
Type the numbering prefix if required |
|
Suffix input box |
Type the numbering suffix if required |
|
Wire Terminals options |
Click Yes to wire the terminals Click No to leave them unwired |
Click OK.
The new terminal numbers appear in the drawing.
If you click Yes under Wire Terminals, go to Step 2 of Terminal Block Wiring below.
Copyright © 2005 - PROCAD Software. All Rights Reserved