www.kxcad.net Home > ProCAD Index > ProCAD 2D DESIGNER 2007
From the Terminal Blocks tab, select Terminal Block.
In the drawing, click where you want to insert the terminal block.
The Terminal Block dialog box appears.
In this dialog box, do the following:
|
In this… |
Do this… |
|
Direction options |
Click the required direction image |
|
Number of Terminals input box |
Type the number of terminals required |
|
Number Terminals options |
Click Yes to number the terminals Click No to leave the terminals un-numbered |
|
Starting Number input box |
Type the number at which you want the terminal numbering to start; available only if you select Yes under Number Terminals |
|
Increment input box |
Type the value by which you want the terminal numbering to increase; available only if you select Yes under Number Terminals |
|
Prefix input box |
Type the numbering prefix if required; available only if you select Yes under Number Terminals |
|
Suffix input box |
Type the numbering suffix if required; available only if you select Yes under Number Terminals |
|
Wire Terminals options |
Click Yes to wire the terminals Click No to leave them unwired |
Click OK.
The terminal block appears in the drawing.
If you clicked Yes under Wire Terminals, go to Step 2 of Terminal Block Wiring.
Copyright © 2005 - PROCAD Software. All Rights Reserved