Attributes

Your Ad Here

This page of the Drawing Setup Wizard is concerned with the customisation of the Pipeline Attribute areas on the Title block, i.e. those areas shown highlighted in magenta.

To add a new attribute:

Click the +/- button to invoke the Drawing Frame Attributes dialogue:

Select the attribute (or attributes) to be added from the left-hand pane.
Click the > button and the attribute is added to the right-hand pane.
Click Quit to exit the dialogue.
The new attribute is located on the left-hand side of the drawing frame.
Position as required, by graphically selecting and moving it, then adjust its position by editing this in the attribute grid.

To remove attributes:

Click the +/- button to invoke the Drawing Frame Attributes dialogue.

Select the attribute (or attributes) to be removed from the right-hand pane.
Click the < button and the attribute is removed from the right-hand pane.
Click Quit to exit the dialogue.

To graphically move an attribute:

Select it with the LHB so that it is highlighted in red and the pointer changes to a cross.
Select it again and move it to a new position.

To select a specific attribute graphically to edit its value in the attributes grid:

Select an attribute box and it and the attribute is highlighted in red in the attributes grid.

Double click in the field of the attribute to be edited.
Type in the new value followed by Enter.

Alternatively, select the value required from a pop-up menu (i.e any value without units, e.g. Font).

To change the column widths in the attributes grid:

Click and drag the left or right edge of the column to increase or decrease the width.

To copy and paste attributes:

Use Copy from Pop-up menu (on the RHB) to copy the attribute value:

Paste the attribute value:

See

Project Defaults