Traceability and unique part numbers has three types of output:

1. Unique part numbers shown at each component on the drawing.

2. A table of Unique part number on the drawing.

3. An output file with Unique part numbers with spool Ids and optionally pipeline reference.

The control of which facility is being used is as follows: -

The property UniquePartNumber on the Traceability object controls the generation of the Unique part number. If this is set to OFF then no Unique part numbers are generated and all facilities are disabled.

If set to either Numeric or Alpha, then the Unique part number will be shown at each component with either a Numeric or Alpha suffix, e.g. 3.1 or 3.a.

To output a table of Unique part numbers the property PlotUniquePtNoTable on the Traceability object must be set to True, and the following properties controlling the position and size of table must be set. The frame of the table must be part of the backing sheet.

• ContinuousDown

• StartX

• StartY

• VerticalSpacing

• TextHeight

• MaxEntries

• TableOverflow

• DrawingLayer

To output a file, the property Path on the Traceability object must be set to the path name for the file, and the Enabled property set to True.