Any Weld numbers in the PCF or IDF will be kept, or if none exist, then Weld numbers will be assigned by ISOGEN, during import, and kept. Weld numbers assigned on import will use the SGImport style settings.

Any Weld numbers in the PCF, IDF, or assigned by ISOGEN, during import, will be cleared.

Note. This is equivalent to I-Sketch and SPOOLGEN's Tools>Weld Numbers>Clear menu command.

Any Weld numbers in the PCF,  IDF, or assigned by ISOGEN, during import, will be cleared and new Weld numbers will be assigned. Weld numbers assigned will be per pipeline with all Welds having one sequence.

Note. This is equivalent to I-Sketch and SPOOLGEN's Tools>Weld Numbers>Assign menu command.

The action depends upon whether it is the first time the pipeline has been processed, or if it is a subsequent processing of the same pipeline.

• Pipeline processed for the first time

• Subsequent processing of same pipeline

Any Weld numbers in the PCF, IDF, or assigned by ISOGEN during import, will be cleared and new Weld numbers will be assigned using the style specified in the property Repeat Style. If the settings in the Repeat Style are set to match those used in the design phase, then consistency is maintained between the design and fabrication phase.

Any Weld numbers in the PCF, IDF, or assigned by ISOGEN, during import, will be cleared. Weld numbers which were assigned during the initial run, which are stored in the Pipeline Object Data (POD) file, will be reinstated. Any new Weld numbers will be assigned using the style specified in the property Repeat Style. If the settings in the Repeat Style are set to match those used in the design phase, then consistency is maintained between the design and fabrication phase.