Any Part numbers in the PCF or IDF will be kept, or if none exist, then Part numbers will be assigned by ISOGEN, during import and kept. Part numbers assigned on import will use the SGImport style settings.

Any Part numbers in the PCF, IDF, or which were assigned during import by ISOGEN, and will be cleared.

Note. This is equivalent to the I-Sketch and SPOOLGEN's Tools>Part Numbers>Clear menu command.

Any Part numbers in the PCF, IDF, or which were assigned during import by ISOGEN, and will be cleared and new Part numbers will be assigned. Part numbers assigned will be per pipeline.

Note. This is equivalent to I-Sketch and SPOOLGEN's Tools>Part Numbers>Assign menu command.

The action depends upon whether it is the first time the pipeline has been processed, or if it is a subsequent processing of the same pipeline.

• Pipeline processed for the first time

• Subsequent processing of same pipeline

Any Part numbers in the PCF, IDF, or which were assigned during import by ISOGEN, will be cleared and new Part numbers will be assigned using the style specified in the property Repeat Style. If the settings in the Repeat Style are set to match those used in the design phase, then consistency is maintained between the design and fabrication phase.

Any Part numbers in the PCF, IDF, or which are assigned during import by ISOGEN, will be cleared. Part numbers which were assigned during the initial run, which are stored in the pipeline object data (POD) file, will be reinstated. Any new part numbers will be assigned using the style specified in the property Repeat Style. If the settings in the Repeat Style are set to match those used in the design phase, then consistency is maintained between the design and fabrication phase.