|
Drawing Area |
|
|
|
|
|
Drawing Area |
|
|
|
|
This page of the Drawing Setup Wizard is concerned with the customisation of the drawing area, i.e. the area contained within the blue highlighted border.
To change the margins by selection:
Using the LHB, select the margin to be changed by clicking on it, then release the LHB.
The margin will be highlighted in red and the cursor updates from a pointer to a cross to show that the margin is now selected and ready to be altered.
Move the cross until its over the margin, then depress, drag to a new position, then release.
The margin's position is changed and the new value is shown in the Margins table.
|
Tip: To accurately fit the Drawing area, Zoom In to each corner of the area being defined, then re-position the margins individually which meet at each corner, by selecting and dragging them. |
To change the margins by editing values:
Double click in the field of the margin to be edited.
Type in the new value followed by Enter.
See
See also
