Template >> Projector >> Add / Edit

• Template >> Projector >> Add / Edit command adds projectors to a template or edits their shell-end points.

Step   

Execute Template >> Projector >> Add / Edit command as follows:

1. Select Template >> Projector >> Add / Edit from the menu or click the corresponding icon from the Template toolbar.

2. Pick a template to add or edit projectors, then projector candidate points are displayed as following.

    3. To add projectors, push Add Projectors on the right mouse popup menu.

4. Move cursor on the candidate points. The point below the cursor is highlighted as following.

 

5. Pick a point on template and a shell point on the desired position.

 

6. To edit projectors, push Edit Projectors on the right mouse popup menu.

 

7. Pick a projector point on the shell and drag it to desired position.

 

8. Push Done to complete this command.

Note  

• For better result when apply template, don't place the projectors too close to each other at the ends of curves.