Inspection >> Dimension >> Recalculate All

• Inspection >> Dimension >> Recalculate All command recalculates all the dimensions.

Step

         Execute Inspection >> Dimensions >> Recalculate All command as follows:

1. Select Inspection >> Dimensions >> Recalculate All from the menu or click the corresponding icon from the Inspection toolbar.

2. The result is that all the dimensions are recalculated.

Note  

• Inspection >> Dimension >> Recalculate All is useful for mass inspection.
• This function cannot recalculate dimensions created by the options of [On Shell] or [On Section]
• Each created dimension is registered to the Dimensions node under the Inspection tree in the Project Tree Window like shown below. If red arrowhead appears in the front of one dimension, it is impossible to recalculate the corresponding dimension. If green arrowhead appears in the front of one dimension, it is possible to recalculate the corresponding dimension. 

          If right-click on the dimension items here, a pop up menu appears like shown below:

        Show/Hide toggles on/off the display status of the corresponding dimension. Rename allows you to change the name of the dimension. If Delete is clicked, the corresponding dimension is deleted. Recalculate is the same as Inspection >> Dimension >> Recalculate All.