Inspection >> Annotation >> Add >> At Min. Deviation

• Inspection >> Annotation >> Add >> At Min. Deviation command creates and displays an annotation for the place where there is smallest deviation,

Step   

Execute   Inspection >> Annotation >> Add >> At Min. Deviation command as follows:

Before you begin, either Whole Deviation or Section Deviation should exist.

1. Select Inspection >> Annotation >> Add >> At Min. Deviation from the menu or click the corresponding icon from the Inspection toolbar.

Result

• The annotation information for the maximum deviation is created like shown in the following picture:

Note  

• Each created annotation is registered to the Annotations node under the Inspection tree in the Project Tree Window. If right-click on the annotation items here, a pop up menu appears like shown below:

        Show/Hide toggles on/off the display status of the corresponding annotation. Rename allows you to change the name of the annotation. If Delete is clicked, the corresponding annotation is deleted. Export is the same as Inspection >> Annotation >> Export All. Recalculate is the same as Inspection >> Annotation >> Recalculate All.