Curve >> Trim >> Curve / Curve

• Curve >> Trim >> Curve / Curve command trims two curves at their intersection points.

กก

Step   

Execute Curve >> Trim >> Curve / Curve command as follows:

1. Select Curve >> Trim >> Curve / Curve from the menu or click the corresponding icon from the Curve toolbar.

2. Select two curves to be trimmed by clicking the left mouse button.

3. After click the right mouse button, the following popup menu appears. Select Pause to stop the current command and change the viewpoint. 

Result

• If selected curves is crossed each other, Two selected curves are divided into four curves and 2 additional curves are registered to the project tree and the current layer of layer window.
• In case there is no intersection points between two selected curves, the following warning message appears. 

         If user select Yes, then rapidform automatically extend or trim curves so that curve have a connection after operation. otherwise, rapidform will escape commend

Note  

• Curve >> Trim >> Curve / Curve command can be applied to two curve residing on different shells.
• The trimmed curve can be twisted after trimming between a closed curve and another closed curve.