Points > Order Scanlines (applicable to point objects that were captured with a line scanner) converts unordered scanline data to ordered data.
Remove Outliers checkbox and Spacing decimal field - specifies that points be rejected if they are more than Spacing distance from any other.
Reduce Noise checkbox and Noise Level slider - performs a degree of smoothing on the surface that is suggested by the captured points. This operation is per-scanline.
Spacing decimal field - specifies the exact distance between points in the grid-like structure of the ordered data.
Max. Edge Length decimal field - specifies the maximum length of any side of any rectangular cell. Gaps in the data that are wider than this value are considered to be holes in the object.
Max. View Deviation decimal field - specifies the change in the scanner angle that causes one scan object to terminate and another to be started automatically. All points in an ordered data object must be visible from a single point of view, so this field controls the automatic breakdown of a “complex” scan into multiple single-view scans.
Filter Angle decimal field (0.0 to 90.0 degrees) - offers the ability to ignore points collected by the scanner beyond the specified angle. This can result in cleaner data. This operation, like smoothing, is per-scanline.
Keep Original Data checkbox - specifies that the unordered object shall not be deleted from the Model Manager when the ordered object is created.
OK button -performs conversion and saves a new ordered point object in the Model Manager.
Cancel button - terminates the dialog without converting an unordered point object to ordered.