Feedrate - Specifies the feed movement speed of the tool. This is feed per minute, or feed per revolution (default), as selected using the Feed Type (M-Functions menu) command.
Speed - Specifies the spindle speed of the turning centre in revolutions per minute . If you have previously selected Constant Surface Speed using the CSS (M-Functions) command, this spindle speed is measured in surface speed (metres or feet) per minute.
Z Offset - Specifies an offset in Z to apply to the profile boundary.
X Offset - Specifies an offset in X to apply to the profile boundary.
Digitise Start - Check to select a cycle start position when entering co-ordinate data for the cycle.
Safe Approach - Check to use the Safe Approach strategy on the initial approach move. This causes approach moves to be split into two separate blocks. If a radially mounted tool is in use the approach will be in the order Z and then X. For an axially mounted tool the order will be X and then Z.
Feature Name - Enter a name here to allow labelling of digitised information for this cycle to enable "pickup" of this information in another (similar) cycle.