Toolpath - Choose the method of toolpath generation:
Centreline - Compensation is set to 'Pathtrace'.
Centreline + Compensation - Compensation is set to 'Pathtrace' and Cutter Compensation is set to 'Left' or 'Right'.
Geometry - Compensation is set to 'Controller' and Cutter Compensation is set to 'Left' or 'Right'.
Lead In/Out - Decide how the Lead Distance is to be applied. Choose between <None>, Line or Arc.
Lead Distance - If you have specified a lead in/out, this is either the distance along the line or the radius of the arc move.
Offset - Specifies the distance (in addition to the tool radius) the tool is offset from the outer profile.
Tool Type - Specifies the tool for finishing the profile.
ToolStore - Press the Find button to open the ToolStore. Pick the appropriate tool and click Select.
Feedrate - Specifies the rate of movement in the workplane.
Plunge Feed - Specifies the rate of movement in the direction of the tool axis.
Speed - Specifies the tool spindle speed in RPM.
Position - Specifies the tool's position number on the turret.
Sort Priority - Assigns a sort priority to the toolchange and its associated instructions. Rationalising by tool will then be performed by order of first use within each priority group. All tools with the same priority will be sorted in order of first use, followed by those with the next priority and so on in ascending numerical order.
If a sort priority has been assigned to a toolchange this priority will be displayed in the Instructions Browser to the right of the instruction number.
By default, this field is set to non-modal. It will default to blank and you will need to specify a priority, if required.
Diameter - Specifies the diameter of the tool.
Corner Radius - Defines the radius of the corner at the cutting end of the insert.
Small Diameter - Defines the smaller diameter of a taper tool
Included Angle - Defines the included taper angle of the tool.