Cut Increment - Specifies the maximum depth of each successive cut. This must be a positive value.
Cusp Height - Specifying this generates an effective cut increment at each level, which will not be exceeded. If specified, Cut Increment must also be specified. The Cut Increment is used instead of the Cusp Height if it is lower than the effective cut increment.
Draft Angle - Defines the draft angle from the vertical. The angle is always a positive number ranging from >0 to <90. The draft angle runs from the cycle level to the depth.
Upper Radius - Defines a blend radius between the profile level and the draft wall.
Lower Radius - This is a blend radius between the depth and the draft wall.
Sharp Corner - If this box is checked, the cutter can move past the profile (by radius of the cutter) to maintain a sharp corner. If this box is unchecked, a round corner type will be used. The cutter is kept in contact with the profile and this may result in an arc move in the toolpath.