www.kxcad.net Home > CAM Index > EdgeCAM Index >
Arc Centres/Hole Features
These settings are useful, for example, if you want to save time by digitising multiple geometry (by dragging out a rectangle), with the geometry you don't want to drill being filtered out.
The 'Diameters' for these settings are feature Diameter properties or the arc diameters (wireframe).
|
As Tool Diameter |
Check to only drill holes with the same diameter as the tool (within the 'Tolerance' value below). |
|
Check this to drill holes defined by incomplete arcs (as well as complete ones). | |
|
Minimum Diameter |
Holes with a diameter less than this will not be drilled. |
|
Maximum Diameter |
Holes with a diameter more than this will not be drilled. |
|
Tolerance |
The tolerance for 'As Tool Diameter' above. |
Lines
|
Vertical |
Check to set level and depth from vertical line, any non-vertical lines will be ignored. |