www.kxcad.net Home > CAM Index > EdgeCAM Index >
Associative (Clearance) - Check this for the Clearance value to be incremental from the highest point of the feature you digitise. Uncheck this for the Clearance value to be absolute. If you digitise a wireframe profile this parameter has no effect.
Level - Specifies the absolute height at which the cycle is to start. Specified as an absolute or incremental value - see Associative (Level) below.
Associative (Level) - Check this for the Level value to be incremental from the highest point of the feature you digitise. Uncheck this for the Level value to be absolute. If you digitise a wireframe profile this parameter has no effect.
Depth - Specifies the total depth to which you wish to machine. As the Depth is incremental to the Level, this is typically a negative value. Alternatively, input a calculation for the depth.
Cut Increment - Specifies the depth of material to remove with each successive pass, until the tool reaches the specified Depth. This must be a positive value.