www.kxcad.net Home > CAM Index > EdgeCAM Index >
These parameters define how entities to be drilled are filtered. (Not available in axial drilling)
Arc Centres
As Tool Diameter - Check to only drill arcs of the same diameter as the tool (plus or minus tolerance specified below).
Incomplete Arcs - When checked, incomplete arcs (i.e. arcs that are not a full circle) will be drilled.
Minimum Diameter - Specifies the minimum arc size to be drilled.
Maximum Diameter - Specifies the maximum arc size to be drilled.
Tolerance - Specifies the tolerance used when matching tool to arc.
Lines
Vertical - Check to set level and depth from vertical line, any non-vertical lines will be ignored.
5.0 Compatibility
Drill Duplicates - (Compatibility switch) EdgeCAM automatically detects pre-version 5.0 drilling cycles and checks this box when coincidental drill points are found.