www.kxcad.net Home > CAM Index > EdgeCAM Index >
"Rest machining" allows you to machine rest material areas that have been left by a larger tool in a previous machining cycle (not limited to Flat Land Finishing, previous cycle may have been Roughing or Parallel Lace for example).
Choose between the following three modfiers to define the rest material area:
Previous Tool Diameter - Specifies a tool diameter value for the tool that will define the rest machining area.
Previous Corner Radius - Specifies a corner radius value for the tool that will define the rest machining area.
Previous Stand Off - (Only available when previous cycle was Flat Land Finishing cycle) Specifies a stand off distance value that will define the rest machining area. The Stand Off Distance is specified on the General tab of the cycle.