www.kxcad.net Home > CAM Index > EdgeCAM Index >
Parallel Lace and Z Level each have their own set of lead in and lead out parameters:
Angle In - Enter the included angle of the radius applied to the start of the toolpath stripe (0 < Angle In <=90). If the radius has not been entered, the Length modifier is used.
Angle Out - Similar to Angle In but the parameter is applied to the end of the stripe. If Constant Cut has NOT been checked, the Angle In and Angle Out parameters are switched on alternate passes, so that each end of the cycle is consistent.
Radius In - Enter the value of the radius used at the start of each toolpath stripe.
Radius Out - Similar to Radius In but the parameter is applied to the end of the stripe. If Constant Cut has NOT been checked, the Radius In and Radius Out parameters are switched on alternate passes, so that each end of the cycle is consistent.
Length In - Enter the value of a linear lead in onto the start of toolpath stripe. If a radius is specified, the tool leads onto the arc at a tangent.
Length Out - Similar to Length In but the parameter is applied to the end of the stripe. If Constant Cut has NOT been checked, the Length In and Length Out parameters will be switched on alternate passes, so that each end of the cycle is consistent.