www.kxcad.net Home > CAM Index > EdgeCAM Index >
See also: Creating Lines
Creates different types of lines. This command is equivalent to selecting the toolbar command Line Dialog.
Polyline - Check to create a series of connected lines. You can check this in combination with Orthogonal to create a series of orthogonal connected lines.
Horizontal - Check to create horizontal lines.
Vertical - Check to create vertical lines.
Orthogonal - Check to create lines that can either be vertical or horizontal. You can check this in combination with Polyline to create a series of orthogonal connected lines.
Tangent To Point - Check to create a line which is tangential to an arc and ends at a point.
Tangent To Tangent - Check to create a line which is tangential to two arcs or their extensions.
Angle - Specifies a specific angle for the line.
Relative Angle - Specifies an angle for the new line relative to another line.
Parallel - Creates a parallel line at a distance from an existing line.
Parallel 2 - As above but one line is created on each side of an existing line.
Tangent And Angle - Creates a line which is tangential to an arc at a specified angle.
To X, Y, Z Co-Ordinate - Creates a line which stops when the specified co-ordinate is reached.
Length - Specifies a length for the line.
Name - Specifies a name for the line entity. Use this name later to select the entity.