www.kxcad.net Home > CAM Index > EdgeCAM Index >
See also: Trimming Entities
Use this command to trim one or more entities against another entity. Note that "trim" will extend an entity to the intersection point or truncate it back to that point as appropriate.
First - Check this box to trim the first digitised entity against the second.
Second - Check this box to trim the second digitised entity against the first.
Break - Check this box to specify a break point on an entity with the first digitise followed by two digitises to determine either side of the break.
Multiple - Check this box to use the first digitised entity to specify where all subsequently digitised entities are to be trimmed.
Please note that entities other than lines and arcs are converted to b-splines when trimmed, e.g. trimming a continuous consisting of lines and arcs will convert the continuous into a B-spline (entity number will not change).