www.kxcad.net Home > CAM Index > EdgeCAM Index >
Use this dialog to stretch (elongate or shorten) one or more entities.
Notes
Wholly enclosed entities are translated, not stretched.
Symbols will only be moved if their origin lies within the window.
Arcs and curves will only be moved if they are completely contained within the window - they are then translated, not stretched.
If the entities have associated toolpaths, these are updated when you regenerate. However, user defined start and end positions will not be retained.
It
is not possible to stretch dependent entities (cross hatching and some
surfaces) or the entities upon which they are dependent.
|
X, Y, Z |
How the stretching is to occur in each axis: None - If an axis is left as <None>, no stretching takes place in that direction. Digitise - Specify the amount of stretch with digitises. Value - Specifies the amount of stretch in a particular direction. |
|
Layer |
The layer on which to place the transformed entities. |