Note that once a toolpath has been edited this way, it
is no longer a normal machining instruction and cannot be regenerated.www.kxcad.net Home > CAM Index > EdgeCAM Index >
See also: Editing the Toolpath
This command lets you change part of a toolpath between two selected points. Toolpaths that have been edited will be shown with an appropriate comment after the command name in the instruction list.
Note that once a toolpath has been edited this way, it
is no longer a normal machining instruction and cannot be regenerated.
Location - Check to move a node on the toolpath. Arc moves change
into linear moves if repositioned.
Screen Snap - Check to select the toolpath from the screen, rather than from the instruction list.
Rapid - Check to change the toolpath section to all rapid moves.
Feedrate - Specifies the tool feedrate in the workplane for the toolpath section.
Plunge Feed - Specifies the vertical tool feedrate (into and out of the workplane) for the toolpath section.
Speed - Specifies the spindle speed to be used for the toolpath section.