www.kxcad.net Home > CAM Index > EdgeCAM Index >
See also: Converting to a Continuous Entity
Use this command to turn a meeting point between entities within a continuous entity into a chamfered or radiused corner.
All - Check this box to blend all corners on the selected continuous entity. If unchecked, only the corner nearest to the digitise is blended.
Blend Radius - Specifies the radius of the blend if required.
Angle - Specifies the angle of the chamfer relative to the first line. This modifier must be used with one of the Lead, Length or Trail parameters.
Length - Specifies the length of the chamfer. If no other parameters are used, the chamfer is created symmetrically.
Lead - Specifies the distance along the first digitised line, between the end of the chamfer and the intersection point of the two lines. If no other parameters are used, the chamfer is created symmetrically.
Trail - Specifies the distance along the second digitised line, between the end of the chamfer and the intersection point of the two lines. If no other parameters are used, the chamfer is created symmetrically.