www.kxcad.net Home > CAM Index > EdgeCAM Index >
See also: Creating a Chamfer
Use this command to turn a meeting point between two entities into a chamfered corner.
Trim First Entity - Check the box to trim the first digitised line back to the chamfer. Clear the box to leave the line untrimmed.
Trim Second Entity - Check to trim the line digitised second back to the chamfer. Clear the box to leave the line untrimmed.
Angle - Specifies the angle of the chamfer relative to the first line. This modifier must be used with one of the Lead, Length or Trail parameters.
Length - Specifies the length of the chamfer. If no other parameters are used, the chamfer is created symmetrically.
Lead - Specifies the distance along the first digitised line, between the end of the chamfer and the intersection point of the two lines. If no other parameters are used, the chamfer is created symmetrically.
Trail - Specifies the distance along the second digitised line, between the end of the chamfer and the intersection point of the two lines. If no other parameters are used, the chamfer is created symmetrically.