Rest Roughing the Part

Repeat the previous Roughing operation as summarised below, but with slight changes (marked '*'):

1. In the Operations toolbar click Roughing.

2. Select the whole solid. Select no boundaries.

3. In the General tab, set Rest Rough to checked *, set Offset to 0.2, set Digitise Stock to unchecked * (you can leave the other settings as they are).
   
   

4. In the Tooling tab select the tool 6 mm Endmill - long series* from the ToolStore (you can leave the other settings as they are).

5. In the Depth tab set Clearance to 5, Level to 0, Depth to 0 and Cut Increment to 2. Click OK to close the dialog and generate the operation (there will be no prompt for stock).