Pencil Milling (Operations menu) is a finishing operation making a single pass along internal edges. Please note that the Pencil Mill operation only supports ballnose cutters.
|
|
Pencil Milling (Operations menu) is a finishing operation making a single pass along internal edges. Please note that the Pencil Mill operation only supports ballnose cutters. |
A new pencil mill cycle was introduced in EdgeCAM version
7.50. Please note that the Pencil Mill operation uses the "old"
(i.e. pre-version 7.50) cycle.
See Also
Sequence of Instructions in the Pencil Mill Operation
Using the Pencil Mill Operation