Adding the machining cycles in the Upper Turret

1. From the Tooling menu select Turret. Ensure the upper turret is selected and click OK.

2. From the Tooling menu select ToolStore.

3. Select the Mill tab and in the tools list select 14mm endmill. Click the Select button.

4. In the Turn toolbar or the M-Functions menu click Synchronise Turrets and in the dialog click OK.
   
   

5. Zoom in around the component.

6. From the M-Functions menu select Planar Mode.

7. From the Move menu select Rapid, press the X key to type coordinates. In the Command box type 0Z10 after the existing 'X' entry and click OK,  then right-click to terminate the command.