Completing the 2D Geometry

To create a pocket in the middle of the model

  1. In the Design toolbar click Rectangle.

  1. In the Rectangle dialog that appears, click in the Length box and type 40. Similarly set Width to 30, Depth to 0 and Corner Radius to 5. Click OK.

  1. To position the rectangle press the X key on the keyboard. In the Enter Co-ordinates dialog that appears click in the Command box and type '0Y0'  against the existing 'X'. Click OK.

    The rectangle is drawn at the origin of the part (X0Y0).

  1. Right-click to finish.

 The 2D Geometry creation is now complete.