Profiling the Inner Profile (Upper Boss)

www.kxcad.net Home > CAM Index > EdgeCAM Index >

1. In the Operations toolbar click Profiling.

2. The Status Bar now prompts you to 'Digitise Profile(s)'. Move the cursor over the top edge of the upper boss until a 'tooltip' appears indicating '2D Boss'. Click to select the boss then right-click to terminate the profile selection.

3. The Profiling dialog now opens. In the General tab set: Mill Type to Climb, Tolerance to 0.01, Offset to 0, Compensation to None, Lead Radius to 4.
   
   
   
   Don't click OK yet.