In the Simulator toolbar click 
and
select one of:
To specify where you want the simulation to stop:
In the Simulator toolbar click and
select one of:
Stop at End - Stops simulation at the end of the sequence.
Stop at Collision - Stops simulation at the next collision.
Stop at Toolchange - Stops simulation at the next toolchange.
Stop at Index Move - Stops simulation at the next index move.
Stop at Turret Change - Stops simulation at the next turret change. Also, with twin turret turning, at the Synchronise Turrets instructions.
Stop at Fixture Change - Stops simulation at the next fixture change.
Stop at Cut # - Stops simulation after the specified cut number.
Stop after # Cuts - Stops simulation after specified number of cuts.
If you selected one of the '#' options in a drop
down list, enter the number into the dialog that opens.
(A drop down list appears if you click the '▼' part of the button,
whilst a dialog opens if you click the main part of the button. The list
and the dialog contain the same options.)
|
|
Note that once the simulation stops, an indication of why it stopped appears in the bottom left of the simulator; if you had set a 'Stop at Cut #', for example. |
