Turning Macro Reference
Recommended Syntax
%MACRO=5=..=Finish Turn Cycle=4,5,7,12,30,31,21,
Note that 12 is optional and enables the Constant Offset
modifier in the cycle dialog.
|
System Variables Modified |
System Variable Description |
|
ENDSUB |
End Subroutine Block Number |
|
FEED |
Feedrate |
|
FIELD1 |
Lead in Angle |
|
FIELD2 |
Lead in Radius |
|
FIELD3 |
Lead in Length |
|
FIELD4 |
Lead out Angle |
|
FIELD5 |
Lead out Radius |
|
FIELD6 |
Lead out Length |
|
FIELD7 |
Start Point Z co-ordinate (if FIELD9=1) |
|
FIELD8 |
Start Point X co-ordinate (if FIELD9=1) |
|
FIELD9 |
Digitise Start (Point): 0 = Start point specified by current tool position 1 = Billet specified by digitised position 2 = Geometric or toolpath billet selected |
|
FIELD10 |
Corner Type: 0 = Round corners 1 = Square corners |
|
OFFSETX |
X Axis Offset Value |
|
OFFSETZ |
Z Axis Offset Value |
|
PATHTRACE |
Controller Canned Cycle Flag |
|
SPEED |
Spindle Speed |
|
STARTSUB |
Start Subroutine Block Number |
|
SUBROUTINE |
Subroutine identifying number |
|
XEND |
X Axis End Position of profile |
|
XSTART |
X Axis Start Position of profile |
|
ZEND |
Z Axis End Position of profile |
|
ZSTART |
Z Axis Start Position of profile |