The SYNCHRONISE TURRETS macro causes either turret to wait until the other turret has completed its operations. When the SYNCHRONISE TURRETS command is issued, a 'wait code' is sent to both turrets.
The command can be issued at any point within machining and is not turret dependent. It may also be applied as a retrospective command.
The effect of the SYNCHRONISE command is that both turrets will start to perform their operations simultaneously. Normally one turret will finish before the other and will read the SYNCHRONISE command. This instructs the turret to wait until the second turret also reads the SYNCHRONISE command, at which point both turrets are started again.