www.kxcad.net Home > CAM Index > EdgeCAM Index >
To create a slot
Select the Slot (Geometry menu) command. The Slot parameters are displayed.
Complete the parameters, updating default values as required:
Length – Enter a value for the length of the slot or select <Digitise>.
Width – Enter a value for the width of the slot.
Depth – Enter a value in this field to project the slot in the {Z} of the current CPL.
Angle – Enter a value for the angle of the slot or select <Digitise>.
Digitise the start point of the slot.
Digitise the end point of the slot (if necessary).
If you entered a value in the Angle parameter, the direction of the slot will be constrained.
If you entered a value for the Length parameter, the length of the slot will be constrained.