In this dialog box you specify the offset values for the part location. Note that these values are for simulation purposes only.
Enter the offsets for positioning the part on the face. For Y-axis tombstones, enter the offsets from the left and top edges. For X-axis tombstones enter the offsets from the top and right edges. .
Enter the Offset from tombstone face to translate the part away from the tombstone. This distance would represent the thickness of any fixturing.
Click Next.
The Preview dialog box and preview the placement of the part on the tombstone.
If the part placement is acceptable, click Finish.
If you need to adjust the part, click Back and make the necessary adjustments.