This is the second step in creating a new part.
To complete this page:
Select the type of document you want to create. The options you will see are dependent on the options you have licensed including:
Turn for 2-axis turned parts. Remember this is only the type of the first setup of your part. Your part can contain multiple setups and these setups can mix different manufacturing techniques. If you have licensed the turn/mill product you will see the option of Turn/Mill for your turning documents.
Milling for 2 ½ D or 3D milled parts. Once again, this is only the type of your first setup.
WireEDM for parts that you will cut on a wire EDM machine using FeatureWIRE.
Multiple fixture for laying out multiple parts on the table. This indicates that you will be mixing different milled parts for multiple part manufacturing. See Multiple Fixture documentfor more information.
Tombstone for parts that you will mass produce on a horizontal or vertical milling machine.
Select the unit of measure for your part:
Inch
Millimeter
See System units for more information
Click Finish.