Die operations – Sets the default operations for a die feature.
Punch/side operations – Sets the default operations for a punch or side feature.
Die/punch primary cut dir – The default value for primary cut direction variable for die or punch features.
Side primary offset dir - The default value for primary cut direction variable for side features
Retract/cutoff/stop stop length – The default value for Stop Length feature variable
Overlap – The default value for the overlap feature variable.
Retract/cutoff retract length – The default value for retract length feature variable.
Pocket/zig-zag finish allowance – The default finish allowance for pocketing or zig-zag operations.
Stepover – The default stepover for for pocketing or zig-zag operations. This default attribute is specified as a percentage of the wire diameter.
Zig-zag cut angle – The default value for the zig-zag cut angle featue attribute.
Cleanup pass – Check this box to include a cleanup pass on zig-zag or pocketing operations.
4 axis toolpath linear approx – In 4-axis EDM, all arcs are converted into small line segments. This parameter controls how finely arcs are refined into lines. The smaller the number, the more points arcs will be broken down into.