Cycle types
This tab allows you to specify a variety of canned cycles for a hole operation. Select the type of drilling cycle that will perform the operation. After each operation the G-code contained in the current post processor for each cycle is listed in parenthesis.
Drill cycle (commonly G81)
Spot face cycle (commonly G82)
Deep hole cycle (commonly G83)
Chip break cycle (commonly G73)
Tap cycle (commonly G84)
Ream cycle (commonly G89, G85 or G76)
Bore cycle (commonly G98)
Cycle parameters
Dwell
First peck
Second peck
Minimum peck
X shift and Y shift