| Comment |
R/W
| The comments associated with the tool, if any |
| CutterLength |
R/W
| The cutter length of the thread mill tool |
| DefaultHolder |
R/O
| The default holder for the tool |
| DefDiaRegister |
R/W
| The diameter cutter compensation offset register for the tool |
| DefLenRegister |
R/W
| The tool length offset register for the tool |
| DefToolID |
R/W
| The tool ID register for the tool |
| DefToolSlot |
R/W
| The tool slot number for the tool |
| Diameter |
R/W
| The diameter of the side mill tool |
| ExposedLength |
R/W
| The exposed length of the tool |
| FeedPercentage |
R/W
| The percentage of feed override for the tool |
| Holder |
R/W
| The name of the toolholder |
| InsertLength |
R/W
| The insert length of the plunge mill tool |
| InsertTipRadius |
R/W
| The tip radius of the tool's insert |
| IsCenterCutting |
R/W
| True if the Center Cutting Type checkbox is checked in the tool properties dialog |
| Material |
R/W
| The name of the material for the tool |
| Metric |
R/O
| True if the dimension units of the object are Metric |
| Name |
R/W
| The name of the object. This is the same name that shows up in the tree view of FeatureCAM |
| NumberOfInserts |
R/W
| The number of inserts for the plunge mill tool |
| OverallLength |
R/W
| The overall length of the thread mill tool |
| ShankDiameter |
R/W
| The shank diameter of the thread mill tool |
| SpeedPercentage |
R/W
| The percentage of speed override for the tool |
| ToolFinish |
R/W
| The name of the finish for the tool |
| ToolGroup |
R/O
| The toolgroup containing the tool |