| angle |
R/W
| The End/Side angle of the tool |
| Comment |
R/W
| The comments associated with the tool, if any |
| DefaultHolder |
R/O
| The default holder for the tool |
| DefDiaRegister |
R/W
| The diameter cutter compensation offset register for the tool |
| DefLenRegister |
R/W
| The tool length offset register for the tool |
| DefToolID |
R/W
| The tool ID register for the tool |
| DefToolSlot |
R/W
| The tool slot number for the tool |
| Depth |
R/W
| The depth of the thread tool |
| ExposedLength |
R/W
| The exposed length of the tool |
| FaceMaxDiameter |
R/W
| The maximum diameter of the tool |
| FaceMinDiameter |
R/W
| The minimum diameter of the tool |
| FeedPercentage |
R/W
| The percentage of feed override for the tool |
| Holder |
R/W
| The name of the toolholder |
| HolderBottomClearance |
R/W
| The bottom clearance of the tool holder |
| HolderFrontClear |
R/W
| The front clearance of the tool holder |
| HolderHeight |
R/W
| The height of the tool holder |
| HolderLength |
R/W
| The length of the tool holder |
| HolderOrientation |
R/W
| The orientation of the tool holder. See tagFMTurnHolderOrientation |
| InscrCircDia |
R/W
| The inscribed circle diameter |
| InsertShape |
R/W
| The insert shape for the tool |
| InsertTipAngle |
R/W
| The tip angle of the tool's insert |
| InsertTipRadius |
R/W
| The tip radius of the tool's insert |
| InsertWidth |
R/W
| The width of the tool's insert |
| IsLeftHandTool |
R/W
| True if the thread tool's insert is left handed |
| IsSideCut |
R/W
| True if the thread tool is side cut |
| Material |
R/W
| The name of the material for the tool |
| Metric |
R/O
| True if the dimension units of the object are Metric |
| Name |
R/W
| The name of the object. This is the same name that shows up in the tree view of FeatureCAM |
| SpeedPercentage |
R/W
| The percentage of speed override for the tool |
| ToolFinish |
R/W
| The name of the finish for the tool |
| ToolGroup |
R/O
| The toolgroup containing the tool |
| Type |
R/W
| The type of the lathe tool. Available types are defined by tagFMTurnToolType |