Lesson 23: Change Your Viewpoint of the Scene

You need to adjust your viewpoint of the scene so that you can see the entire building.

To change viewpoint:

1. Place the cursor over the Trackball control on the Controls palette.
   
   The cursor changes to double crossed arrows.
2. Click and drag the Trackball to the right.
   
   The scenes rotates counter clockwise in the scene window.
3. Continue dragging until the blue camera wireframe is on the left side of the window and the center wireframe lines of the front and back walls line up in the center of the window, looking like the following figure.
   
   
   
   You are now looking through the doorway of the building,
4. Place the cursor on the bottom Z arrow of the XZ Camera control.
5. Drag up on the XZ Camera control until you can see the entire front wall of the building.
   
   The scene should look like this.
   
   
6. Save your scene and call it Grouped Building.

Copyright © 2005-2007, DAZ Productions