Form: Show Solid Loads
Click the Display menu > Show Load Assigns > Solids command to display the Show Solid Loads form and specify the solid loads to be shown on the model in the active window.
Load Name. Select the load case for which the loading is to be displayed.
Load Type. This area of the form will have several selections, some of which will not be available because that type of loading has not been included in the model. Select the Load Type, and where applicable, the Coordinate System, Face and Component. Choose to display values or contours.
Click the OK button. If the OK button is not available, no loads have been assigned to solids in the model.
Note: Only one loading can be displayed on the model at a time.
See Also
Assign - Solid Loads - Gravity
Assign - Solid Loads - Pore Pressure
Assign - Solid Loads - Surface Pressure
Assign - Solid Loads - Temperature
Assign - Solid Loads - Vehicle Response Components