When the Design menu > Steel Frame Design > Verify All Members Passed command is used, the program reports if structural members passed the stress/capacity check.
Use the Design menu > Steel Frame Design > Verify All Members Passed command as follows:
Click the Analyze menu > Run Analysis command to run an analysis.
Click the Design menu > Steel Frame Design > Start Design/Check of Structure command to run the design.
Click the Design menu > Steel Frame Design > Verify All Members Passed command.
SAP2000 will display a pop-up box indicating the outcome of the verification. If members do not pass the check, the Change Design Section command can be used to change the design section.
Example: Use of this command is demonstrated in Problem C.